ENDO MANUFACTURING CO.,LTD. Stock Forecast

Evaluation of ENDO MANUFACTURING CO.,LTD. stock downgraded after the last trading session.
(Updated on Jun 28, 2024)

7841.T Signals & Forecast

The ENDO MANUFACTURING CO.,LTD. stock holds buy signals from both short and long-term Moving Averages giving a positive forecast for the stock. Also, there is a general buy signal from the relation between the two signals where the short-term average is above the long-term average. On corrections down, there will be some support from the lines at JP¥1,287.00 and JP¥1,122.11. A breakdown below any of these levels will issue sell signals. Furthermore, there is a buy signal from the 3 month Moving Average Convergence Divergence (MACD). Some negative signals were issued as well, and these may have some influence on the near short-term development. A sell signal was issued from a pivot top point on Thursday, June 27, 2024, and so far it has fallen -0.0761%. Further fall is indicated until a new bottom pivot has been found. Volume fell together with the price during the last trading day and this reduces the overall risk as volume should follow the price movements.

Support, Risk & Stop-loss for ENDO MANUFACTURING CO.,LTD. stock

ENDO MANUFACTURING CO.,LTD. finds support from accumulated volume at JP¥1,312.00 and this level may hold a buying opportunity as an upwards reaction can be expected when the support is being tested.

This stock may move much during the day (volatility) and with a large prediction interval from the Bollinger Band this stock is considered to be "high risk". During the last day, the stock moved JP¥28.00 between high and low, or 2.18%. For the last week, the stock has had daily average volatility of 4.44%.

The ENDO MANUFACTURING CO.,LTD. stock is overbought on RSI14 and lies in the upper part of the trend. Normally this may pose a good selling opportunity for the short-term trader, but some stocks may go long and hard while being overbought. Regardless, the high RSI together with the trend position increases the risk and higher daily movements (volatility) should be expected. A correction down in the nearby future seems very likely and it is of great importance that the stock manages to break the trend before that occurs.

Our recommended stop-loss: JP¥1,266.99 (-3.50%) (This stock has high daily movements and this gives high risk. The RSI14 is 76 and this increases the risk substantially. There is a sell signal from a pivot top found 4 days ago.)

Trading Expectations (7841.T) For The Upcoming Trading Day Of Monday 1st

For the upcoming trading day on Monday, 1st we expect ENDO MANUFACTURING CO.,LTD. to open at JP¥1,304.33, and during the day (based on 14 day Average True Range), to move between JP¥1,256.25 and JP¥1,369.75, which gives a possible trading interval of +/-JP¥56.75 (+/-4.32%) up or down from last closing price. If ENDO MANUFACTURING CO.,LTD. takes out the full calculated possible swing range there will be an estimated 8.64% move between the lowest and the highest trading price during the day.

Since the stock is closer to the resistance from accumulated volume at JP¥1,314.00 (0.08%) than the support at JP¥1,312.00 (0.08%), our systems don't find the trading risk/reward intra-day attractive and any bets should be held until the stock is closer to the support level.

Is ENDO MANUFACTURING CO.,LTD. stock A Buy?

Several short-term signals, along with a general good trend, are positive and we conclude that the current level may hold a buying opportunity as there is a fair chance for ENDO MANUFACTURING CO.,LTD. stock to perform well in the short-term. Due to some small weaknesses in the technical picture we have downgraded our analysis conclusion for this stock since the last evaluation from a Strong Buy to a Buy candidate.

Current score: 3.463 Buy Candidate Downgraded

Predicted Opening Price for ENDO MANUFACTURING CO.,LTD. of Monday, July 1, 2024

The predicted opening price is based on yesterday's movements between high, low, and closing price.